General information on the rental process can be found here.
Rental equipment can only be shipped within Germany and Austria.
Rental to other EU countries may also be feasible after consultation. Send us a short request by e-mail to support[at]radonshop.com
Product information "Electrosmog measuring kit MK20 rental"
Contains the instruments ME3830B and HF35C. Allows an easy evaluation of the personal exposure to HF and LF electrosmog according to the guidelines and recommended safe values of the "Standard of Building Biology Measuring Techniques" (© Maes, IBN). The HF-device includes the very useful feature of an acoustic analysis for a reliable identification of the various pulsed HF sources, and the LF-device has an extended frequency range designed to also measure the artificial harmonics.For detailed specifications of the devices please refer to the respective product descriptions.
Product information "Low Frequency Analyser ME3830B"
The reading shows the total pollution without any calculation required. The measured values are reliably displayed directly in the entity corresponding to the building biology standard values, namely: The electric field strength from 1 to 1999 V/m (against ground potential)The magnetic flux density from 1 to 1999 nT.An acoustic signal proportional to the field strength with "Geiger-counter-effect" helps identifying regions with increased exposure.
Comprises all features of the ME3030B, and additionally offers:
- A clearly extended frequency range: from 16 Hertz to 100 Kilohertz. This frequency range (in accordance with SBM) also includes the higher frequencies caused by, for instance, energy saving lamps, switching-mode power supplies, electronic dimmers, or monitors, which are considered especially critical.
Technical Data ME3830B
| Frequency range: | 16 Hz - 100 KHz (compensated, better than -2 dB). |
| Measurement range: | Magnetic flux density (unidimensional): 1 - 1999 nT Electric field strength: 1 - 1999 V/m |
| Accuracy: | +/- 2 %, +/- 14 digits @ 50/60 Hz |
| Sensor: | E-field sensor for electrical LF- fields H-field sensor for magnetic LF-fields (one-dimensional) |
| Audio analysis: | acoustic signal proportional to the field strength with "Geiger-counter-effect" |
| Signal rating: | RMS |
| Power supply: | 9 Volt Alkaline manganese battery (included), average operation time 24-36 Hours |
Product information "RF-Analyser HF35C"
Audio analyses for the identification of pulsed radiation sources (mobile radio (GSM, UMTS/G3), cordless telephones (DECT), WLAN (Bluetooth), air-traffic control radar) by means of an acoustic signal proportional to the modulation frequency. Display of peak value as well as average value (switchable).Sensitivity increased by a factor of 10 (from a minimum display resolution of 0.1µW/m² to a maximum of 1999 µW/m²).HINT: Our best-selling meter for the easy evaluation
Technical Data HF35C
| Frequency range: | 800 MHz - 2.7 GHz |
| Measurement range: | Power flux density: 0.1 - 1999 µW/m² |
| Accuracy: | Basic accuracy (CW) including linearity tolerance: +/- 6 dB Zero offset and rollover +/- 9 digits |
| Sensor: | Logarithmic periodic antenna |
| Audio analysis: | Identification of pulsed radiation sources (mobile radio (GSM, UMTS/G3), cordless telephones (DECT), WLAN (Bluetooth), air-traffic control-radar) by means of an acoustic signal proportional to the modulation frequency |
| Signal rating: | Display of peak value as well as average value (switchable) |
| Power supply: | 9 Volt alkaline manganese battery (included), average operation time 6 - 7 hours Low-Batt. indication, auto-power-off |
Frequency range MK20 - SET
There are no reviews yet.
